The usual way to put a durable threaded interface into a 3D print is to use a heat-set insert, but what about other options? [Thomas Sanladerer] evaluates a variety of different threaded inserts, none of which are actually made with 3D printing in mind but are useful nevertheless.
from Pocket
via Did you enjoy this article? Then read the full version from the author’s website.
Layer lines are a dead giveaway to non-normies that a thing was 3D printed. There are things you can do to smooth them — sanding, chemical smoothing, and fillers come to mind. Although this technique technically uses all three, it starts with something very simple.
from Pocket
via Did you enjoy this article? Then read the full version from the author’s website.
Marble runs are fun enough on their own, but what if you could eat the marbles? Gumballs are the satisfying answer to that question. To that end, [Adrian Seeley] whipped up a system for producing gumball runs programmatically for entertainment and candy dispensing purposes.
from Pocket
via Did you enjoy this article? Then read the full version from the author’s website.
When we first started 3D printing, we used ABS and early slicers. Using supports was undesirable because the support structures were not good, and ABS sticks to itself like crazy. Thankfully today’s slicers are much better, and often we can use supports that easily detach.
from Pocket
via Did you enjoy this article? Then read the full version from the author’s website.
The trick to producing great 3D printing time-lapse animations is to ensure that the extruder has moved out of the frame each time a photo is taken — which usually requires OctoPrint to be controlling both the camera and printer.
from Pocket
via Did you enjoy this article? Then read the full version from the author’s website.
Please take a moment to read this; it will only appear on your first visit (or whenever you clear your cookies).
from Pocket
via Did you enjoy this article? Then read the full version from the author’s website.